Kyle Campbell's latest activity

Except that's not really possible without rebuilding the stations. There's not really clearance below to lower it. There's clearance...

No, but the tunnel itself is quite large, there's ample room for something like Montreal's MP-10. The underground stations though are a...

OC transpo released some numbers today Line 2 and 4 usage (combined but almost entirely line 2): 24.4k trips, which would put it...

I went out earlier this week to ride the LRT again. Though the eastbound trip took 49 minutes, the westbound trip took 15 minutes linger...

Happens with a lot of embedded track switches Ice chunks get trapped between the switch blades and impede their ability to move fully by...

Ottawa also runs theirs on twice the Line 6 nominal voltage (1 500 V DC for Ottawa vs 750 V DC for Line 6) which not only allows the...

That's actually a good point that I hadn't thought of, pokey acceleration isn't one of the flaws that people complain about here

Are there any heaters on the platform? In Ottawa the Line 1 platforms are open, but the Transecure area (aka DWA) always has heaters and...

I've been reading back in the thread, just for "fun." It's pretty crazy to read comments from Summer 2023 when January 2025 was a...

Very large cities like Paris and Istanbul do LRT quite well actually. An LRT should work fine on this corridor, even at grade. It's...

Smartest person in the room here. Thank you for pointing out the obvious. All this attention on TSP, and its great, because TSP is...

Far side atops actually make sense, when you combine them with TSP, the train glides through a green light and then waits on the far...

What I don't understand is, ignoring TSP, why is it so much slower than the bus. The bus has to wait at all the lights too. You'd expect...

The trillium line could definitely be faster, but compared to Finch it's Lightning McQueen. But even with the slow zones and curves...

I think it's a culmination of a few things. As much maligned as Metrolinx is, it is the catalyst for getting projects started again in...